Shaktim Place a spool of thread on the horizontal spool pin and press a spool cap onto the spool pin to hold the thread spool firmly in place. Connect the three-prong plug into the brogher. The needle clamp can be replaced. To check the needle, place the flat side of the needle on a flat surface.

Author:Fenrijind Dokazahn
Language:English (Spanish)
Published (Last):6 October 2013
PDF File Size:6.1 Mb
ePub File Size:13.61 Mb
Price:Free* [*Free Regsitration Required]

Sounds like brtoher need to tighten the screws, use a coin or screw driver. The distance in the scale between two lines of the same length is 0. Not finding what you are looking for? Threading the Right Needle Follow the same instructions for single needle threading using the thread from the spool on the extra spool pin.

Page 27 Page 28 — Longueurs et largeurs recommandees pour Replace the sewing light bulb. Do not touch the plug with wet hands. Page 21 The sewing needle must always be straight and sharp for smooth sewing. The bobbin winder shaft is slid to the right. To print the manual completely, please, download it. Reverse sewing is used for back tacking and reinforcing seams. Always unplug this machine from the electrical outlet immediately after using and before cleaning.

When unplugging the machine, always turn off the main brpther first. If, you need a copy of your manual go to www. It is a Brother XR With the flat side of the needle facing the back, insert the new.

Doing so could cause a fire or an electric shock. The accessories are stored in a compartment under manuak flat bed attachment cover, which be opened by flipping it toward you. Or point us to the URL where the manual is located. If yes, Make sure your feed dogs are up Change the foot to the Zigzag presser foot.

If this machine is fitted with a 3 pin non-rewireable BS plug then please read the following. Document Outline The needle could break and cause injury. Connect the power supply plug into a wall outlet. Raise the presser foot using the Presser Foot Lever. Instructions for repacking the machine are illustrated.

When sewing the left side of the zipper, attach the shank to the right pin of the zipper foot. It is recommended that a test sample be made on a fabric scrap before sewing on your project. If the wrong presser foot is used, the needle may strike the presser foot and bend or break, and may cause injury.

Turn the main power switch to OFF before changing the. Replace bulb with same type rated 15 watts. Enter text from picture: The needle may break, leading to injury. When sewing with the twin needle, manjal sure the Stitch Width Dial is not set above 3 since this may cause the needle to hit the needle plate and break.

Possible misadjustments and their results. The Pattern Selection Dial may brkther turned in either direction. Baste the cut design to the fabric in the location where desired. If the plug fitted is not suitable for the power point in your home or the cl is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer.

To check the needle, place the flat side of the needle on a flat surface. Retirer la fiche de la prise secteur. If the problem continues, the following check list may help you to improve the operation. Tell us about it. Always use the correct presser foot for the selected stitch pattern. If the needle is not completely inserted or the needle. Sew the fabric on the bias, placing it under the presser foot so that the straight stitches are sewn on the seamline and the zigzag stitches are sewn slightly over the folded edge.

It is recommended to practice making a buttonhole on a scrap piece of fabric before attempting it on the actual garment. The following zl shows the recommended range of stitch lengths and widths. For a button with a diameter of 1. Most 10 Related.





Brother XL-6562 User Manual



Brother XL-6562 Instruction Manual


Related Articles